When the Epson WF-2750 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson WF-2750 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

What Causes the Epson WF-2750 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson WF-2750 waste counter reset in minutes.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson WF-2750 Waste Counter Reset

1. Step 1: Prepare a Windows PC + USB cable and connect Epson WF-2750 directly. Keep Internet enabled for validation.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson WF-2750 is detected.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson WF-2750 to finalize.

Most Epson WF-2750 waste counter resets finish in ~1–2 minutes.

What You Need

• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).

Frequently Asked Questions