Blog

Epson SX125 Reset Waste Ink Counter

Epson SX125 Waste Ink Counter Reset

Epson SX125 Waste Ink Counter Reset

When the Epson SX125 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson SX125 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson SX125 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson SX125 waste counter reset in minutes.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson SX125 Waste Counter Reset

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson SX125 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson SX125.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson SX125 to finalize.
Buy Wic Reset Key

Most Epson SX125 waste counter resets finish in ~1–2 minutes.

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson SX125 – Waste Ink Counter Reset using Wic Reset Connect.

Vélemény, hozzászólás?