Blog

Epson ME-10 Reset Waste Ink Counter

How to Reset Epson ME-10 Waste Ink Counter

Epson ME-10 Waste Ink Counter Reset

When the Epson ME-10 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ME-10 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson ME-10 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ME-10 waste counter reset in minutes.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson ME-10 Waste Counter Reset

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson ME-10 directly. Keep Internet enabled for validation.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson ME-10 is detected.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ME-10.
Buy Wic Reset Key

Most Epson ME-10 waste counter resets finish in ~1–2 minutes.

Troubleshooting

  • Restart printer and PC, then try again.
  • Try another USB cable (some cables are charge-only).
  • Run the app as Administrator.
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).

FAQ

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson ME-10 – Waste Ink Counter Reset using Wic Reset Connect.

Vélemény, hozzászólás?