When the Epson ET-2860 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2860 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ET-2860 Waste Ink Counter

Most Epson ET-2860 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Reset Epson ET-2860 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson ET-2860 directly. Keep Internet enabled for validation.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2860.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-2860.

Most Epson ET-2860 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• Windows 7/8/10/11 PC

Common Fixes

• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.