When the Epson ET-2724 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson ET-2724 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

What Causes the Epson ET-2724 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-2724 waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson ET-2724 Printing

1. Step 1: Connect Epson ET-2724 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2724 appears in the device list.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson ET-2724.

Most Epson ET-2724 waste counter resets finish in ~1–2 minutes.

System Requirements

• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.

FAQ