Blog

Epson WorkForce 645 Reset Waste Ink Counter

Epson WorkForce 645 Ink Pad Counter Reset Guide

Epson WorkForce 645 Waste Ink Counter Reset

The Epson WorkForce 645 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WorkForce 645 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson WorkForce 645 Stops Printing (Waste Counter Limit)

Most Epson WorkForce 645 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Three Steps to Restore Epson WorkForce 645 Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson WorkForce 645 via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson WorkForce 645 appears in the device list.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WorkForce 645.
Buy Wic Reset Key

Most Epson WorkForce 645 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Use a direct USB connection (avoid hubs).
  • Try another USB cable (some cables are charge-only).
  • Run the app as Administrator.
  • Restart printer and PC, then try again.
  • Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson WorkForce 645 – Waste Ink Counter Reset using Wic Reset Connect.

Deja una respuesta