When the Epson M100 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson M100 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson M100 Ink Pad Counter Warning?

Most Epson M100 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Three Steps to Restore Epson M100 Printing

1. Step 1: Prepare a Windows PC + USB cable and connect Epson M100 directly. Keep Internet enabled for validation.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson M100 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson M100.

Most Epson M100 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)

Common Fixes

• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).

Frequently Asked Questions