Blog

Epson ET-M1108 Reset Waste Ink Counter

Reset Epson ET-M1108 Waste Ink Counter in Minutes

Epson ET-M1108 Waste Ink Counter Reset

The Epson ET-M1108 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson ET-M1108 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson ET-M1108 Ink Pad Counter Warning?

Most Epson ET-M1108 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Step-by-Step: Epson ET-M1108 Waste Counter Reset

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-M1108 via USB (Wi-Fi reset is not supported).
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson ET-M1108 is detected.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson ET-M1108 to finalize.
Buy Wic Reset Key

Most Epson ET-M1108 waste counter resets finish in ~1–2 minutes.

Troubleshooting

  • Temporarily disable VPN/proxy if validation fails.
  • Use a direct USB connection (avoid hubs).
  • Restart printer and PC, then try again.
  • Run the app as Administrator.
  • Try another USB cable (some cables are charge-only).

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson ET-M1108 – Waste Ink Counter Reset using Wic Reset Connect.

Deja una respuesta