Blog

Epson XP-400 Reset Waste Ink Counter

Epson XP-400 Ink Pad Counter Reset Guide

Epson XP-400 Waste Ink Counter Reset

When the Epson XP-400 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson XP-400 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson XP-400 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-400 waste counter reset in minutes.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson XP-400 Waste Counter Reset

  1. Step 1: Connect Epson XP-400 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson XP-400 is detected.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson XP-400.
Buy Wic Reset Key

Most Epson XP-400 waste counter resets finish in ~1–2 minutes.

What You Need

  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson XP-400 – Waste Ink Counter Reset using Wic Reset Connect.

Schreibe einen Kommentar