When the Epson TX112 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX112 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX112 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX112 waste counter reset in minutes.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Step-by-Step: Epson TX112 Waste Counter Reset

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX112 via USB (Wi-Fi reset is not supported).
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX112 appears in the device list.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson TX112 to finalize.

Most Epson TX112 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.