The Epson L101 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L101 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson L101 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson L101 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson L101 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson L101 directly. Keep Internet enabled for validation.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson L101 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L101.

Most Epson L101 waste counter resets finish in ~1–2 minutes.

System Requirements

• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.