When the Epson ET-2814 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson ET-2814 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson ET-2814 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson ET-2814 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson ET-2814 Waste Ink Counter in 3 Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-2814 via USB (Wi-Fi reset is not supported).
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2814.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson ET-2814.

Most Epson ET-2814 waste counter resets finish in ~1–2 minutes.

What You Need

• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key

Troubleshooting

• Run the app as Administrator.
• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).